Heart Balloon Modeling

Step 1: Take the balloon of the size 260 and inflate it, leaving about 3"/8 cm uninflated at the end. You will need them to move the air inside the balloon as you twist. Look at the proportions of the model shown on the picture.

Step 2: Make the bubbles, starting from the knotted end, and twist them in one direction by one hand. Hold the bubbles you’ve made in the other hand to prevent them from untwisting. Make one bubble of middle size and one small round bubble. Repeat the chain twice. Then make one long bubble and one small round bubble. You’ll have the left side of the heart. Twist the bubbles of the right side of the heart the same way but in reverse order. Make the chain of two round bubbles and one smaller round bubble between them at the end.

Step 3:

Step 4: Make the bottom corner of the heart, bending both sides upward.

Step 5: Connect the ends of the balloon, bending the bubbles in the shape of a heart.

Step 6:

Step 7: Twist two big round bubbles together several times.

Step 8: The heart is complete.

Lesson added by Sergey Burlakov